Bender offers with his Ladecontroller A universal way to control the charging process. You can load excess PV stream from your solar system into your car via the OCPP interface.

Thanks to the integration with us, the wall box can be operated from anywhere and controlled intelligently.

Preparation

Around the Bender LadeController It is necessary to connect with us to activate the OCPP backend of the Wallbox.

Before starting the furnishings, you have to use WiFi or LAN your wall box connect to the internet And the latest Install updates.

In order to set up the OCCP baking, access via a web browser is necessary. You usually need the IP address of your wallbox And enter it in the browser line. Instructions for this will also give you provided by the manufacturer.

Furnishings

Ideally, you carry out the setup via a desktop PC, laptop or tablet, since the furnishings are more comfortable here. Add a new wall box with us and choose Bender out of.

If you put on the wallbox with us, then you will be yours in the Wallbox menu Individual OCPP-URL displayed.

Copy the OCPP-URL and put them in the Bender LadeController.

Open your browser and connect to the charging controller that you enter the IP address in the address line.

Go to the menu [Backend] -> [OCPP] and put the URL and forgive one [Chargepoint ID], this must not "" or underlined "_"

Then you can check the settings again if there are problems with the charging control. As a rule, however, the required ones are used via the backend after the first connection Settings automatically set.

After a restart, the Wallbox automatically connects to our backend, which can take a few minutes. Maybe a charging process must also be started so that the Wallbox connects us for the first time.

As soon as the connection to your Wallbox is established, it will appear in the dropdown under your OCPP URL.

Now you can make the remaining wall box settings and save your wall box.